Ugly7
Homebuilt Pusher AP plane/7th generation - V tail

24 oz AUW with Pencam SD

2000mah 2 cell Lipoly (14amp max)
Uberall "Nippy Black" 1812/100 External Rotor Brushless Motor = $79.00 
Jeti 18 Amp brushless controller = $65.90
9x6 APC prop = $2.50
Full size Futuba 7 channel RX R127DF = $73.00
2 Hitec HS81 servos = $34.00
Lost model alarm from FoamFly.com = $15.00
Schieppati digital switch = $15.00

Fuse made of EPP packing foam from computers:
Boom is CF arrow shafts.
33" nose to tail
6.5" at tallest point (motor mount)
5" tall snout
17.5" foam fuse length
8" long wing saddle

V-Tail:
110 degree V with balsa crossbar.
Each piece:
8.5" wide
2" control surface
3.5" fixed surface

The wing started out as a standard undercamber with 15 degrees of
dihedral. 60" wide -- 2 30" pieces, hand formed with 6 total ribs to hold
shape. Then the bottom was skinned with crossman target foam creating a
flat bottom wing.  6.5" chord. 6" tip. I used rolled .2" CF tubes CA'ed
and taped to LE joined by a 2" bent coathanger wire and secured with
poly-glue. The crossbar (hopefully replacing wire bracing) is .125"
pulltruded CF tube with a bamboo T for added strength all secured with CF
tow and soaked with CA. The TE has a short bamboo spar.