Ugly6
Homebuilt Pusher AP plane/6th generation - Function over form design

27oz AUW

2000mah 2 cell Lipoly (14amp max)
GWS EPS400C/E motor
10x8 prop
Great Planes C50 ESC
Full size Futuba 8 channel RX
2 Hitec HS81 servos
Lost model alarm from FoamFly.com
HP435 3.1MP camera (don't like it)
Schieppati digital switch

Fuse made of EPP packing foam from computer monitors:
Boom is aluminum arrowshaft.
40" nose to tail
7" at tallest point
4" tall snout
21.5" foam fuse length
10" long wing saddle

Elevator:
14" wide
2" control surface
3.25" fixed surface

Rudder:
6" tall
3.25" control surface at longest point
5.5" fixed surface

The wing is a standard undercamber with 15 degrees of dihedral. 62" wide
-- 2 31" pieces, hand formed with 6 total ribs to hold shape. 6.5" chord.
6" tip. I used rolled .2" CF tubes CA'ed and taped to LE joined by a 2"
bent coathanger wire and secured with poly-glue. The crossbar (hopefully
replacing wire bracing) is .125" pulltruded CF tube with a bamboo T for
added strength all secured with CF tow and soaked with CA. The TE has a
short bamboo spar.

First test in 10-15+ MPH winds.  Some instability was observed, but
managable.  Power was sub-par.  Flight successful.  Wing also tested on
Ugly5 and found to be quite decent.  Hoping to get brushless in the near
future.